Plug and Play Owie V2 Installation Guide

This guide walks through the Plug and Play Owie V2 installation for Nexus Battery Solutions products. Follow each connection step carefully and confirm every connector is seated before reassembly.

Warning: You must use the wires included in the packaging to install the Plug and Play chip. Stock wires will not work.

View original document Back to documentation

Installation Diagram

Use this diagram to identify the main Owie V2 connection points: lighting power, board power, board data, and harness data.

Plug and Play Owie V2 installation diagram
Owie V2 installation diagram showing the main connector locations.

6-Pin Communication Connection

  1. Connect the 6-pin connector from the wiring harness to the 6-pin port on the chip labeled IN.
  2. Connect the 6-pin wire from the kit into the PCB 6-pin port, then connect the other side to the 6-pin port on the stock OneWheel control board.
Owie V2 harness 6 pin connection
Step 1: harness 6-pin connection to the Owie V2 chip.
Owie V2 6 pin to board connection
Step 2: 6-pin connector routed from the Owie V2 chip to the control board.

3-Pin Power Connection

  1. Connect the 3-pin connector from the chip side labeled IN to the stock control board's 3-pin connector.
  2. Connect the 3-pin connector from the chip side labeled OUT to the LED board in the front of the controller housing.
Owie V2 3 pin power connection
Step 3: 3-pin power connection.
Owie V2 LED board connection
Step 4: LED board connection at the front of the controller housing.

Mount the Chip

Peel the backing and stick the Owie V2 chip to the lid so it is secured before reassembly.

Owie V2 chip mounted to lid
Step 5: chip mounted to the lid.
Owie V2 final install reference
Final reference image showing the completed wiring layout.

Disclaimer

Installing aftermarket modifications may affect the operation and safety of your board. Installation is performed at your own risk. Nexus Battery Solutions is not liable for damage, injury, or loss caused by improper installation or use. If you are not comfortable performing the install, have it completed by a qualified technician. Always disconnect power and use appropriate safety gear before working on electronics.